Motorola MCPN750A Benutzerhandbuch

1-26

Computer Group Literature Center Web Site

Hardware Preparation and Installation

The TMCPN710 or TM-PIMC-0001 Transition Module may be required 
to complete the configuration of your particular MCPN750A system. If so, 
perform the following install steps to install this board. For more detailed 
information on the TMCPN710 or TM-PIMC-0001 Transition Module 
refer to the corresponding users guide, i.e., TMCPN710 Transition Module 
Installation and Use (TMCPN710A/IH) or TM-PIMC-0001 Transition 
Module Installation and Use (TMPIMCA/IH) manual.

If PIMs have already been installed on the TM-PIMC-0001, or you are 
installing a transition module as it has been shipped from the factory, 
disregard this section, and proceed to the main installation section titled 
“Installing the Transition Module in the Chassis.” For PIM installation 
perform the following steps:

1. Attach an ESD strap to your wrist. Attach the other end of the ESD 

strap to the chassis as a ground. The ESD strap must be secured to 
your wrist and to ground throughout the procedure.

2. Perform an operating system shutdown. Turn the AC or DC power 

off and remove the AC cord or DC power lines from the system.

3. Remove chassis or system cover(s) as necessary for access to the 

CompactPCI.