Extron electronic PMK 155 Merkblatt

The Extron

®

 PMK 155 Pole Mount Kit is a simple solution for mounting Extron devices and 

their external power supplies to a projector pole. The PMK can be installed on a 1.5-inch 
pipe within a 4-inch space between the projector and the ceiling.
Including the power supply, the following devices can be mounted:

 

z

one three-inch deep half-rack device, or 

 

z

one six-inch deep half-rack device, or

 

z

two three-inch deep quarter rack devices,  
or

 

z

an MPA 401

ATTENTION: The maximum load for the 

PMK 155 is 5 lbs (2.25 kg).

NOTE:  The PMK 155 is to be used only 

with Extron UL listed products. 

NOTE:  Ensure the finished installation is in accordance with local and national buildng 

codes, fire and safety codes, UL requirements, and local and national electrical 
codes. 

To install the PMK 155 (with a device) on a projector pole:

Place the plate on the base of the device and align holes in the plate with the 
mounting holes in the device. 
 

(2) 4-40 x 3/16"
Screws

Use 2 mounting holes on
opposite corners.

Secure the device to the plate with 4-40 screws.

ATTENTION: Use only the screws supplied with the device to avoid damaging it.

Pipe Clamp

Mounting Plate

(2) Tie Wraps

(2) Hex Bolts

(2) Washers