Barco MFGD 3621 Benutzerhandbuch
Attaching the display to an arm stand
49
Attaching the display to an arm stand
The panel, standard attached to the tilt & swivel foot, is compatible with
the VESA 100 mm standard. So it can be used with an arm stand
according to the VESA 100 mm standard.
the VESA 100 mm standard. So it can be used with an arm stand
according to the VESA 100 mm standard.
Therefore, the tilt & swivel foot must be removed from the panel.
Important:
• Use an arm that is approved by VESA (according to the VESA 100
mm standard).
• Use an arm that can support a weight of at least 13 kg (28.66
lbs).
To attach the display to an arm stand:
1.
Put the display face down on a clean and soft surface. Be careful
not to damage the panel screen.
not to damage the panel screen.
2.
Remove the tilt & swivel foot cover.
3.
Remove the small screw (A) fixing the small plastic cover on top of
the foot. Next, remove the small cover itself.
the foot. Next, remove the small cover itself.
Figure 18: Display with tilt & swivel foot cover removed
4.
Unscrew the 2 screws fixing the round plastic cover (B).
5.
Lift up the round plastic cover.
A
B