Fujitsu P42VCA30A Benutzerhandbuch

You can use this option to move the screen position to minimize phosphor-induced “burn-in”.

Follow the steps below.

(1) Select “Screen Orbiter” and press 

.

The “Screen Orbiter” setting screen will appear.

(2) Press 

 or 

 to select “Mode/Time”.

(3) Select a desired pattern.

Each time you press   or  , one of the available choices appears in the following sequence:

Off:

Disables Screen Orbiter.

Time: Moves the pattern approximately every one hour.

Mode: Moves the pattern when the power is turned ON.

(4) Press 

 or 

 to select “Moving Area”.

(5) Press   or   to select the range for moving the pattern.

Each time you press   or  , one of the available choices appears in the following sequence:

Min.: Pattern moves in small range. (About 5 pixels)

Std.:

Pattern moves in moderate range. (About 10 pixels)

Max.: Pattern moves in wide range. (About 15 pixels)

(6) Press 

 to store.

(1) Select “Time” for “Mode/Time” within “Screen Orbiter”.
(2) Select a desired range for “Moving Area” within “Screen Orbiter”.

This causes the screen saver pattern to move in the same range at
regular intervals.

• Select a desired amount of time for “DPMS”.
  Thus, when the display does not receive a signal, it will automatically
  display white or black over the entire screen.  When the predetermined
  time elapses, the power will turn OFF.

The screen protection functions minimize phosphor burn-in but cannot completely eliminate it.

“Screen Orbiter” setting screen

* On-screen information disappears if you do not take any action for about 60 seconds.

* Functions may not be available with some models and some device options.

* The adjustment range varies with the display signal. You can make adjustments to the value you want within the adjustable range.

 E-MDH00771-01(17-21)

03.11.12, 0:58 PM

Page 18

Adobe PageMaker 6.5J/PPC