Benq MX716 Benutzerhandbuch

Operation

20

To adjust the projector (MX716):

1.

Press the quick-release button and lift the 
front of the projector. Once the image is 
positioned where you want it, release the 
quick-release button to lock the foot in 
position.

2.

Screw the rear adjuster foot to fine-tune the 
horizontal angle.

To retract the foot, hold up the projector while 

pressing the quick-release button, then slowly lower 

the projector. Screw the rear adjuster foot in a 

reverse direction.

To adjust the projector (MX717):
Screw the adjuster feet to fine-tune the horizontal 

angle.

To retract the feet, screw the adjuster feet in a 

reverse direction.

If the projector is not placed on a flat surface or the 

screen and the projector are not perpendicular to 

each other, the projected image becomes 

trapezoidal. To correct this situation, see 

 for details.

In some cases, you may need to optimize the picture quality. To do this, press AUTO on 

the projector or remote control. Within 3 seconds, the built-in Intelligent Auto 

Adjustment function will re-adjust the values of Frequency and Clock to provide the best 

picture quality. 

The current source information will be displayed in the corner of the screen for 3 seconds.

This function is only available when PC signal (analog RGB) is selected.

2

1

MX717

MX716

Do not look into the lens while the 

lamp is on. The strong light from the 

lamp may cause damage to your eyes.
Be careful when you press the quick-

release button as it is close to the 

exhaust vent where hot air comes 

from.