Antex electronic SX-6 Benutzerhandbuch
21
8. Make sure “Search for a better driver…” is selected.
9. Select the location of the new driver.
10. Click “Next”. Click “Next”. Click “Next”. Click “OK”.
11. Point to location of driver files again.
12. Click “OK”. Click “Finish”.
13. Click “Yes” to reboot the computer.
WINDOWS NT
1. After installing the Antex Card in the computer, power the
computer back up.
2. From the “Start” menu, select “Run”. In the command line,
type “A:\setup”. Insert the DRIVER disk into the “A” drive.
Click “OK”.
Click “OK”.
3. The software will install itself on your hard drive.
4. The “Antex Audio Driver Setup” window will pop-up. Select
the correct adapter type (SX-36, SX-6, etc.), select 2 devices,
and an I/O address and an interrupt. No other cards in your
system can be using this interrupt or I/O address.
and an I/O address and an interrupt. No other cards in your
system can be using this interrupt or I/O address.
5. There will be a warning box to make sure all audio programs
are closed. Click “Yes”.
6. If the driver can communicate with the Antex Card at the I/O
address and interrupt selected, there will be a message stat-
ing the driver installation was successful. Click “OK”.
ing the driver installation was successful. Click “OK”.