Cisco Systems 694 Benutzerhandbuch

Always use filler panels to fill empty vertical spaces in the rack. This arrangement ensures proper 
airflow. Using a rack without filler panels results in improper cooling that can lead to thermal damage.

Observe the following additional requirements to ensure adequate airflow and to prevent damage to 
the equipment:

Front and rear doors—If the 42U rack includes closing front and rear doors, you must allow 
5,350 sq cm (830 sq in) of holes evenly distributed from top to bottom to permit adequate 
airflow (equivalent to the required 64 percent open area for ventilation).

Side—The clearance between the installed rack component and the side panels of the rack must 
be a minimum of 7 cm (2.75 in).

Rack-mounting the WAVE-594 and WAVE-694 appliance is supported for rear mount in a 4-post rack or 
front mount in a 2-post rack.

 lists the rack mounting hardware included in your shipping container. You will need a Phillips 

screwdriver. Verify that you have received the following items for the installation:

There are two ways you can rack mount the WAVE appliance. The following topics are included in this 
section:

1

Front rack mount 
bracket

Front rack mount L bracket

2

X

X

2

Rear rack mount 
bracket holder

Rear rack mount bracket holder

2

X

3

32” rear rack mount 
bracket

Rear rack mount bracket (32 inch)

2

X

4

Front rack mount 
bracket screw

Front rack bracket screw, #6-32 x 0.30”, Wafer 
Head, Phillips, Steel w/ Zinc and Black

6

X

X

5

Rear rack mount 
bracket holder screw

Rear bracket holder screw, M4 x0.7 x 4.85 mm, 
120º, Flat Head, Phillips, Steel w/ Zinc and Black

6

X

6

Rack screw

Rack screw, #10-32 x 0.50”, Truss Head, Phillips, 
Steel w/ Ni and Black

8

X

X

7

Rack screw

Rack screw, M5 x 12.7 mm, Truss Head, Phillips, 
Steel w/ Ni and Black

8

X