Cisco Systems 694 Benutzerhandbuch

This chapter provides basic instructions for installing hardware options in your WAVE-594 and 
WAVE-694. These instructions are intended for technicians who are experienced with setting up Cisco 
WAVE-594 and WAVE-694 hardware. 

This chapter contains the following sections:

In addition to the two onboard Gigabit Ethernet ports, the WAVE-594 and WAVE-694 can accommodate 
one optional Interface Module network module:

4-port Gigabit Ethernet Copper Bypass Interface Module

8-port Gigabit Ethernet Copper Bypass Interface Module

4-port Gigabit Ethernet Fiber Optic Bypass Interface Module

2-port 10 Gigabit Ethernet Fiber Optic SPF+ Interface Module

For information on the features of the Cisco WAVE Interface Modules and cabling requirements, see 

Interface Modules are not hot-swappable therefore it is necessary to power the system down before 
installing or replacing.

To maintain proper system cooling, do not operate the appliance for more than 1 minute without either 
an Interface Module or a filler panel installed in the bay.

To install a Cisco Interface Module in the Interface Module slot, follow these steps: