3com 7600 Benutzerhandbuch
7-4
C
HAPTER
7: M
ANAGING
ATM R
ESOURCES
Example
Enter:
[4] [2] [1]
The following is a sample ATM address display:
Figure 7-2 ATM Address Display
Update Bridge ATM
Address
Address
Enter the bridge number and the ATM address (or “!” to invalidate the
ATM address) to update the local ATM address. An ATM address entered
by this command will override the ILMI address registration for the
specified bridge. When you change the ATM address manually it must be
coordinated with the ATM switch. Use the invalidate command (“!”) to
reset the ATM address, so as to restore the automatic ILMI address
registration for the specified bridge.
ATM address) to update the local ATM address. An ATM address entered
by this command will override the ILMI address registration for the
specified bridge. When you change the ATM address manually it must be
coordinated with the ATM switch. Use the invalidate command (“!”) to
reset the ATM address, so as to restore the automatic ILMI address
registration for the specified bridge.
Source
The source of the ATM addresses:
Q
Automatically assigned by ILMI
Q
Manually assigned and saved in flash memory
In order to use ILMI automatically, this value should not
be assigned manually.
be assigned manually.
State (in ILMI)
State of the ATM address within ILMI. If no address has
been manually assigned, ILMI is automatically used. In
this case, it should normally be in the Registered state.
been manually assigned, ILMI is automatically used. In
this case, it should normally be in the Registered state.
Table 7-4 ATM Address Fields
Field
Description
--------------------------------------------------------------------
|Bridge|
ATM Address
|Source|State
|
|
|
|
| (in ILMI) |
+------+----------------------------------------+------+-----------+
|
0
|4700000009000000000000000000c0da18050c00| ILMI |*REGISTERD*|
--------------------------------------------------------------------
abtthgde.book Page 4 Tuesday, June 23, 1998 10:29 AM