LightSpeed Technologies Classroom Audio System Merkblatt

Seite von 2
NOTE! 
Most problems are directly related to low 
battery power. Please run through the “Battery 
Check” items first. For remaining troubleshoot-
ing, use known good, fully-charged batteries.
TROUBLESHOOTING GUIDE
1
TIPS ON CLASSROOM AUDIO
Avoid
 wearing jewelry that may rub or bump against  
the microphone.
Turn
 off the REDMIkE during private conversations with a student,  
parent, or other classroom visitor. You can also cover the LED  
lens on top of the REDMIkE to block the signal.
 Recharge
 batteries each night. when recharged nightly, operating  
 time (actual usage) for the transmitters will last through a typical     
 school day.
Five-year Limited Warranty
 
Lightspeed Classroom Audio Systems are guaranteed against malfunction due to defects 
in materials and workmanship for a period of FIVE (5) YEARS, beginning at the date of 
the purchase invoice. If such malfunction occurs, the product will be repaired or replaced 
(at Lightspeed’s option) without charge during the warranty period.
1. warranty on infrared microphones is FIVE (5) YEARS. 
2. warranty on Lightspeed rechargeable batteries, all external cables and wires provided 
by Lightspeed is one (1) year.
3. Prepaid shipping labels are provided by Lightspeed factory or an authorized warranty 
service center for warranty repairs.
4. Warranty does not extend to finish, appearance items, or malfunctions due to abuse 
or operation other than specified conditions, nor does it extend to incidental or 
consequential damages. Repair by other than Lightspeed or its authorized service 
agencies will void this guarantee. Information on authorized service agencies is 
available from Lightspeed Technologies, Inc.
2
3
4
Speak 
in a natural voice. A normal conversational speech level 
will provide an adequate signal. It is not necessary to increase  
the intensity of your voice—the audio system provides  
adequate amplification (approximately 5 – 10 dB) above  
ambient room noises.
Our Service Department (800.732.8999, 5 a.m. – 5 p.m., PST)  
will handle all your repair/replacement needs.
LIGHTSPEED TECHNOLOGIES, INC.  |   www.LIGHTSPEED-TEk.COM   |   800.732.8999
Contact us:
LIGHTSPEED TECHNOLOGIES
11509 Sw HERMAN ROAD
TUALATIN, OREGON 97062 
 TOLL FREE: 800.732.8999
PHONE: 503.684.5538
FAX: 503.684.3197 
www.LIGHTSPEED-TEk.COM
MN0007US01-0
Classroom Audio System
Battery Check
• Confirm
 batteries are charged  
each night. 
• Confirm
 proper batteries are used. 
The REDMIkE requires the Lightspeed 
BA-NH2A27 sensing battery for 
proper charging.
• Make
 sure the REDMIkE is turned off 
while charging so that it will attain a 
full charge. Full charge will last  
seven hours.
• Inspect
 the battery contacts. Clean 
and adjust if necessary.
Hearing Static 
• Ensure
 REDCAT is in optimum 
location (refer to REDCAT placement 
in manual). A single REDCAT will 
cover a 1200 sq. ft. enclosed 
classroom.
• Ensure
 that no other REDMIkE/LT71/
HM70 is operating on the  
same channel.
• If
 an external microphone is in use, 
try another REDMIkE that is known 
to be working (if available) to isolate 
the problem. If static persists with 
“known good” microphone, the 
REDMIkE input jack will need service.
Low Volume or Feedback
 Ensure
 microphone is positioned 
appropriately, just below the  
collar bone. 
• Check
 volume level on the amplifier. 
If the volume is too high, feedback 
will occur. Adjust accordingly.
No Sound From Speaker
• Ensure
 the REDCAT is plugged in  
and is turned on. Confirm that the 
POwER light located on the power 
switch is on.
• Confirm
 signal is being received at 
the REDCAT. The IR signal light will 
be lit (RED) indicating a signal is 
being received.
• Confirm
 that REDMIkE is turned on. 
There will be a BLUE LED on  
the microphone to indicate it is 
powered on.