Asrock K8Upgrade-NF3 K8UPGRADE-NF3 Benutzerhandbuch

2 7

2 7

2 7

2 7

2 7

This item will show when “Multiplier/Voltage Change” is set to [Manual];

otherwise, it will be hidden. You may set the value from [x8] up to [x25] but

no higher than the value of “Processor Maximum Multiplier”. For example, if

the value of “Processor Maximum Multiplier” is [x11], the actual value of

multiplier will be [x11] even if you set this item to a value higher than [x11].

However, for system stability, it is not recommended to adjust the value of

this item.

This item will show when “Multiplier/Voltage Change” is set to [Manual];

otherwise, it will be hidden. You may set the value from [1.550V] down to

[0.800V]. However, for safety and system stability, it is not recommended

to adjust the value of this item.

This item can be set by the code using [Auto]. You can set one of the

standard values as listed: [133 MHz (DDR266)], [166 MHz (DDR333)],

[200 MHz (DDR400)].

The default value of this option is [Disabled]. It will allow better tolerance for

memory compatibility when it is set to [Enabled].

Burst length can be set to 8 or 4 beats. 64 Bit Dq must use the 4 beats.

Use this item to adjust the means of memory accessing. Configuration

options: [Auto], [2.0], [3.0], and [2.5]. The default value is [Auto].

Use this to adjust TRCD values. Configuration options: [Auto], [2CLK], [3CLK],

[4CLK], [5CLK], and [6CLK]. The default value is [Auto].