Panasonic WJ-GXE900 Benutzerhandbuch

HOST page

Perform the setting to restrict hosts (IP addresses) to
access the decoder on this page.
It is possible to restrict access to the decoder by the
"USER RESTRICTION" and the "HOST
AUTHENTICATION".

Notes:

• Click the [SET] button to save the changed settings.

Otherwise, the changed settings will not be saved.

• When using both the "USER AUTHENTICATION"

and the "HOST AUTHENTICATION", access to the
encoder will be restricted as below.

■ Item Descriptions

● HOST AUTHENTICATION

Select "ON" or "OFF" to set whether to apply the host
authentication or not.
However, when using a web browser to perform the
settings, it is necessary to be authenticated
regardless of the "ON" or "OFF" setting.
The default setting is "OFF".

● SETUP

Up to 8 hosts can be registered. When a host is
registered, it is displayed in the pull-down menu in
the "DELETE" section on this page.
No host is registered at the default setting.

HOST IP ADDRESS/ SUBNET MASK

Enter the IP address and the subnet mask of the
devices allowed to access the decoder.
Based on the entered IP address and subnet mask,
the decoder calculates the valid address range.
The devices in this range are allowed to access the
decoder.
For example, if "192.168.0.1" is entered for the
"HOST IP ADDRESS" and "255.255.255.0" is
entered for the "SUBNET MASK", the valid range will
be "192.168.0.1" - "192.168.0.255".
The "HOST IP ADDRESS" and the "SUBNET MASK"
can be set in the range of "0.0.0.0" to
"255.255.255.255".

ACCESS LEVEL
Select one of the following for the access level.

1 (ADMINISTRATOR)
It is possible to perform the settings on the settings
pages and operate the decoder using the CGI
commands.
2 (CONTROL)
It is possible only to operate the decoder using the
CGI commands. It is not possible to perform the
settings on the settings pages.

CGI command

Access level check

Host authentication

Access permitted

User authentication

Access denied