Texas Instruments SPRU938B Benutzerhandbuch
www.ti.com
2
Peripheral Architecture
2.1
Clock Control
VLYNQ
CLKDIR=0
DMxxx device
VLYNQ_CLK
VLYNQ
CLKDIR=0
VLYNQ device
VLYNQ
CLKDIR=1
DMxxx device
VLYNQ_CLK
VLYNQ
CLKDIR=1
VLYNQ device
VLYNQ
internal
sys clk
Don’t
care
care
Peripheral Architecture
This section discusses the architecture and basic functions of the VLYNQ peripheral.
The module's serial clock direction and frequency are software configurable through the CLKDIR and
CLKDIV bits in the VLYNQ control register (CTRL). The VLYNQ serial clock can be sourced from the
internal system clock (CLKDIR = 1) or by an external clock source (CLKDIR = 0) for its serial operations.
CLKDIV bits in the VLYNQ control register (CTRL). The VLYNQ serial clock can be sourced from the
internal system clock (CLKDIR = 1) or by an external clock source (CLKDIR = 0) for its serial operations.
The CLKDIV bit can divide the serial clock (1/1 - 1/8) down when the internal clock is selected as the
source. The serial clock is not affected by the CLKDIV bit values, if the serial clock is externally sourced.
source. The serial clock is not affected by the CLKDIV bit values, if the serial clock is externally sourced.
The reset value of the CLKDIR bit is 0 (external clock source).
The external clock source is shown in
. The internal clock source is shown in
.
Figure 2. External Clock Block Diagram
Figure 3. Internal Clock Block Diagram
VLYNQ Port
10
SPRU938B – September 2007