Transition Networks CPSMC0100-210 Benutzerhandbuch

2

24-hour Technical Support: 1-800-260-1312 -- International: 00-1-952-941-7600

CAUTION: Wear a grounding device and observe electrostatic discharge
precautions when installing the media converter slide-in-module into the
single-slot chassis.  Failure to observe this caution could result in damage to,
and subsequent failure of, the slide-in-module media converter.

Note: The maximum power capacity for the chassis slot is 12 Watts.

Note: The CPSMC0100-210 chassis is rated as “Class B” only when Class B

compliant slide-in-module media converters are installed.  The chassis
will drop to a “Class A“ rating whenever a Class A slide-in-module
media converter is installed.

To install a slide-in-module into the single-slot chassis:

1.

Refer to the user’s guide that comes with the slide-in-module to ensure
that any switches or jumpers on the slide-in-module circuit board are set
correctly for the site installation.

2.

Carefully align the slide-in-module with the chassis installation guides
and slide the module into the installation slot.  

3.

Ensure that the slide-in-module is firmly seated inside the chassis.

4.

Push in and rotate the attached panel faster screw clockwise to secure the
slide-in-module to the chassis.

techsupport@transition.com -- Click the “Transition Now” link for a live Web chat.

3

The single-slot chassis automatically powers on when connected to an AC
outlet supplying 100-240 VAC.  To power on the single-slot chassis:

1.

Connect the female end of the power cord to the AC power connector on
the front panel of the chassis.  

2.

Plug the male end of the power cord into the correct voltage AC rack or
wall socket.

3.

Verify that the chassis is powered by observing the illuminated LED
power indicator light on the installed slide-in-module.