Planet Technology SW-801 Benutzerhandbuch

 

- 7 - 

This chapter describes how to connect the Switch to your Fast Ethernet 

network. 

A PC can be connected to the Switch via a two-pair Category 3, 4, 5 

UTP/STP straight cable. The PC (equipped with a RJ-45 10/100Mbps 

phone jack) should be connected to any of the 5/8 numbered port. 

The LED indicators for PC connection depend on the LAN card capabilities. 

If LED indicators are not light after making a proper connection, check the 

PC LAN card, the cable, the Switch conditions and connections. The fol-

lowing are LED indicator possibilities for a PC to Switch connection:    The 

LNK/ACT and 100 LED indicators light green for hookup to 100Mbs speed. 

The LNK/ACT lights green, while 100 LED off for hookup to 10Mbps speed. 

A hub (10 or 100BASE-TX) can be connected to the Switch via a two-pair 

Category 3, 4, 5 UTP/STP straight    or crossover cable. The connection is 

accomplished from the hub Uplink (MDI-X) or normal (MDI) port to any of 

the Switch (MDI/MDI-X) ports: 

For a 10BASE-T hub, the Switch LED indicators should light up as the 

following:  

 

100 LED indicator is OFF. 

 

LNK/ACT LED indicator lights green.

 

For a 100BASE-TX hub, the Switch LED indicators should light up as 

the following: 

 

LNK/ACT,100 LED indicators light green.