UNICOM Electric 802.11b+g Benutzerhandbuch

 

- 

 

To set your 802.11g Wireless LAN USB Adapter as an Access Point (AP). In 
access point mode, the 802.11g Wireless LAN USB Adapter will function as an 
access point. This allows you to set up your wireless networks without using a 
dedicated AP device. Up to 16 wireless stations can associate to the 802.11g 
Wireless LAN USB Adapter. 

To the 802.11g Wireless LAN USB Adapter to bridge your wired and wireless 
network, the following requirements must be met： 

1. The 

802.11g Wireless LAN USB Adapter must be installed on a computer 

connected to the wired network. 

2.  Either configure network sharing (refer to the appendix for an example) or 

bridge the two interfaces (wireless and wired) on the computer. 

3.  Set the wireless station’s IP address to be in the same subnet as the computer 

in which the 802.11g Wireless LAN USB Adapter is installed. Refer to 
Configuring the Wireless Station Computer. 

 

Select the Access Point mode, and you will see the following figure.