Nortel Networks NN44200-300 Benutzerhandbuch
Inspecting the server interior
29
2
Loosen the three thumbscrews at the rear of the top cover.
3
Remove the server cover by pulling the cover toward the rear of the
chassis, and then lifting it up and off.
chassis, and then lifting it up and off.
4
Clip the lead from your ESD wrist strap to an unpainted metal section
of the chassis.
of the chassis.
—End—
What is next?
Continue with
.
Inspecting the server interior
Introduction
You should perform a visual inspection for loose components, foreign matter,
or shipping damage inside the server.
or shipping damage inside the server.
CAUTION
When working with interior components, use an ESD wrist strap to
protect static-sensitive components.
protect static-sensitive components.
To inspect the server interior
Step
Action
1
Carefully check all the cards to ensure they are fully seated on the
baseboard.
baseboard.
2
Check for any loose wires or foreign objects, such as loose screws,
inside the chassis.
inside the chassis.
3
Review the slot locations (see
4
Do one of the following:
IF
THEN
you observe any damage
contact your Nortel technical
support representative.
support representative.
Nortel CallPilot
1002rp Server Hardware Installation
NN44200-300
01.01
Standard
5.0
23 February 2007
Copyright © 2007, Nortel Networks
Nortel Networks Confidential
.