Omron CS1W-RPT01 Benutzerhandbuch
13
Specifications and Configurations
Section 1-2
Converting Part of the Transmission Line to Optical Fiber
Two Repeater Units of the same model must be used when part of the trans-
mission line uses optical fiber.
mission line uses optical fiber.
Maximum Configuration of 62 Nodes
The following Controller Link Units/Support Boards must be used to construct
a network with more than 32 nodes:
a network with more than 32 nodes:
CS1W-CLK21-V1
CJ1W-CLK21-V1
3G8F7-CLK21-E-V1
CJ1W-CLK21-V1
3G8F7-CLK21-E-V1
Note
1.
The network will not operate correctly unless all nodes within the network
use the above Units/Boards.
use the above Units/Boards.
2.
Only node addresses 1 through 32 can be used on networks for which 62
nodes have not been enabled.
nodes have not been enabled.
1-2-2
General Specifications
General specifications are the same for the C200HX/HG/HE, CS-series, CJ-
series, CVM1, CV-series, and CQM1H-series PLCs.
series, CVM1, CV-series, and CQM1H-series PLCs.
Wired Controller Link Unit
Wired Controller Link Unit
Twisted-pair cable
Twisted-pair cable
Optical cable (H-PCF or GI)
CS1W-RPT02 or
CS1W-RPT03
Repeater Units
CS1W-RPT03
Repeater Units
Wired Controller Link Unit
Wired Controller Link Unit
Twisted-pair cable
32 nodes max.
Twisted-pair cable
32 nodes max.
CS1W-RPT01
Repeater Unit
Repeater Unit