Omron CS1W-RPT01 Benutzerhandbuch
32
Data Links Procedures
Section 2-1
2-1
Data Links Procedures
2-1-1
Manually Setting Data Links
When the data link mode is set for manual data link table creation, the data
link tables can be input using the Controller Link Support Software or CX-Pro-
grammer. Use the following procedure.
link tables can be input using the Controller Link Support Software or CX-Pro-
grammer. Use the following procedure.
1,2,3...
1.
Install and wire the Units.
2.
Prepare for communications.
3.
Turn ON the power to the PLC.
4.
Connect the Programming Device.
5.
Create I/O tables.
Contents
Method
Nodes
Page
a. Mount the Units to
the PLCs.
---
All nodes
b. Wire the Network.
---
All nodes
Contents
Method
Nodes
Page
a. Set the unit num-
ber.
Use the front rotary
switches.
switches.
CS/CJ-series, CVM1,
and CV-series PLCs
only
and CV-series PLCs
only
b. Set the node
address.
Use the front rotary
switches.
switches.
All nodes
c. Set the baud rate.
Use the DIP switch.
All nodes
d. Set the operating
level.
Use the DIP switch.
C200HX/HG/HE PLCs
only
only
e. Set the terminal
resistance
Use the front switch
for CVM1, CV-series,
CS/CJ-series, and
CQM1H-series PLCs
or the bottom switch
for C200HX/HG/HE
PLCs
for CVM1, CV-series,
CS/CJ-series, and
CQM1H-series PLCs
or the bottom switch
for C200HX/HG/HE
PLCs
.
All nodes
End nodes on the net-
work: ON
All other nodes: OFF
work: ON
All other nodes: OFF
Contents
Method
Nodes
Page
Turn ON the power to
the PLC.
the PLC.
---
All nodes
---
Contents
Method
Nodes
Page
Connect the Program-
ming Console or Con-
troller Link Support
Software.
ming Console or Con-
troller Link Support
Software.
Use the special con-
nection cable.
nection cable.
CS/CJ-series, CVM1,
and CV-series PLCs
and CV-series PLCs
Contents
Method
Nodes
Page
Input the I/O tables.
Use the Support Soft-
ware or Programming
Console.
ware or Programming
Console.
CS/CJ-series, CVM1,
and CV-series PLCs
only
and CV-series PLCs
only
---