Nortel Networks NN43001-318 Benutzerhandbuch

Installation procedures

secondary reference clock. These reference clock sources are
derived from either BRI spans or DSLs (DSL 0 and/or DSL 1).

Note 2: A clock controller is required in every cabinet or MG
1000S that contains a digital trunk.

Install the SILCs and UILCs. See

Remove the SILCS and UILCs, if previously installed. See

Install the PRI hardware. See

Note: This step is required for packet data implementation only.

Connect the ISDN BRI terminals or trunks.

a. Connect the ISDN BRI terminals for line applications:

1. Connect system cables to the cross-connect terminal.

See

2. Cross-connect the DSLs at the cross-connect terminal.

See

3. Connect the terminating resistor to the SILC DSL. See

4. Connect the ISDN BRI terminals to the DSL. See

5. Initialize a Nortel Networks M5317TDX terminal. See

b. Connect the ISDN BRI trunks for trunking applications:

1. Connect the system cables to the cross-connect terminal.

See

2. Cross-connect the DSLs at the cross-connect terminal. See

Nortel Communication Server 1000

ISDN Basic Rate Interface Installation and Commissioning

NN43001-318

01.02

Standard

Release 5.0

20 June 2007