Nortel Networks 4050 Benutzerhandbuch

78 Chapter 3 Managing the network access devices

320818-A

 

To add a network access device and configure it manually, use the following 
command:

/cfg/domain #/switch <switch ID>

where 

 is an integer in the range 1 to 255 that uniquely identifies the 

network access device in the Nortel SNAS 4050 domain.

When you first add the network access device, you are prompted to enter the 
following information:

•

switch name — a string that identifies the switch on the Nortel SNAS 4050. 
The maximum length of the string is 255 characters. After you have defined a 
name for the switch, you can use either the switch name or the switch ID to 
access the Switch menu.

•

type of switch — valid options are 

ERS8300

 and 

ERS5500

. The input is case 

sensitive.

•

IP address of the switch.

•

NSNA communication port — the TCP port for communication between the 
Nortel SNAS 4050 and the network access device. The default is port 5000.

•

Red VLAN ID — the VLAN ID of the Red VLAN configured on the switch.

•

username — the user name for an rwa user on the switch (required for 
Ethernet Routing Switch 8300 only).

The SSH fingerprint of the switch is automatically picked up if the switch is 
reachable. If the fingerprint is not successfully retrieved, you receive an error 
message (

Error: Failed to retrieve host key

). After you have added 

the switch, you must add or import the SSH public key for the switch (see 

The Switch menu displays.

 shows sample output for the 

command and commands on the Switch menu. For more information about the 
Switch menu commands, see