Fuji Bikes FEH381 Benutzerhandbuch
7
2. Troubleshooting
7-7
Error Co
Screen data cannot be
transferred.
transferred.
1) Screen data transfer has never succeeded.
↓
There may be some errors in the settings
on the computer.
There may be some errors in the settings
on the computer.
1) In the [Transfer] dialog box on the editor,
decrease the baud rate by one level. Also
check that the correct COM port is
selected.
check that the correct COM port is
selected.
2) Screen data transfer was possible, but is
disabled now.
↓
The POD may be faulty. Or, there may be
some errors in settings.
The POD may be faulty. Or, there may be
some errors in settings.
2) Check if the modem connection mode is
selected (“Modem Connect Mode”
displayed at the bottom of the Main Menu
screen denotes the mode).
Also perform an RS-232C self-loop test
(page 6-7).
displayed at the bottom of the Main Menu
screen denotes the mode).
Also perform an RS-232C self-loop test
(page 6-7).
3) Only serial transfer is successful.
↓
There may be some errors in the Ethernet
or USB settings.
There may be some errors in the Ethernet
or USB settings.
3) Transfer via Ethernet
Check that the IP addresses set on the
editor and the POD are the same.
Also check if any error due to Ethernet
connection occurs on the POD.
editor and the POD are the same.
Also check if any error due to Ethernet
connection occurs on the POD.
Transfer via USB
Is the USB driver recognized? Has the
driver been installed successfully (page
2-21)?
Is the USB driver recognized? Has the
driver been installed successfully (page
2-21)?
If the problem persists, contact your local
distributor.
distributor.
Symptom
Cause
Solution