Fuji Bikes FEH381 Benutzerhandbuch
4
1. Coin-type Lithium Battery
4-3
Instructio
Battery Replacement Procedure
Replacement batteries are available from us.
1.
Replace the battery “UG30P-BT” within three minutes after the unit is turned off.
If it is not possible to replace within three minutes, use the UG00S-CW editor (cable: UG00C-T) or
a CF card and make a backup copy of data in the SRAM.
If it is not possible to replace within three minutes, use the UG00S-CW editor (cable: UG00C-T) or
a CF card and make a backup copy of data in the SRAM.
• When using the UG00S-CW editor:
1) Start the UG00S-CW editor.
2) Click the [Transfer] icon. The [Transfer] dialog is displayed.
3) Select [Display] for [Transfer Device] and [SRAM Data] for [Transfer Data].
To save a backup copy from the UG00S-CW editor on the server via Ethernet, check
[
[
Transfer through Ethernet/IP Address of the UG30 Equipped with SRAM]. Keep [
Use Simulator] and [
Read Comments in Data Transfer] unchecked.
4) Click the [PC <-] under [Transfer Mode].
5) Save the read data in the “
∗.RAM” file.
• When using a CF card:
For the backup procedure with a CF card, refer to “Chapter 6 POD Operations.”
2.
Turn the unit off. Slide and open the battery holder. The battery in the socket will come into view.
3.
Unplug the battery connector, and remove the battery from the
socket. Take out the battery while pressing the center of the
battery holder cover as shown in the figure.
socket. Take out the battery while pressing the center of the
battery holder cover as shown in the figure.
4.
Set a new battery. Fit the battery into the socket in such a
manner that the red cable side of the battery faces the board
and the cable faces out. Insert the battery in the “a” side first,
and push it down to “a” while inserted in the “b” side.
manner that the red cable side of the battery faces the board
and the cable faces out. Insert the battery in the “a” side first,
and push it down to “a” while inserted in the “b” side.
5.
Plug in the battery connector and slide and lock the battery
holder cover.
holder cover.
6.
Remove the existing caution sticker. Enter a date five years
from now for “Battery Replacement” on the new caution sticker,
and attach it to the backside of the unit.
from now for “Battery Replacement” on the new caution sticker,
and attach it to the backside of the unit.
7.
When the backup copy of the SRAM data has been saved in
step 1, turn on the unit and load the data to the unit.
step 1, turn on the unit and load the data to the unit.
Name
Type
Contents
Replacement battery for the UG30
UG30P-BT
• Coin-type lithium primary cell
1 pce
• Cautions sticker
1 pce
See
ope
ratin
g o
r m
ain
tena
nce
instru
ctio
n fo
r ty
pe o
f b
atte
ry
to b
e u
sed
.
Batte
ry re
pla
cem
ent.
“a” side
Battery holder
Battery
connector
connector
Printed circuit
board
board
“b” side
Socket