Star Micronics IS-NP192 Benutzerhandbuch
3
English
Installing the serial interface unit
• First remove the printer cover by pushing in the tabs located on both
sides of the lower rear of the printer with a screwdriver as illustrated
below.
below.
• Set the DIP switches on the serial interface unit to the settings that you
want. See “Setting the serial interface unit’s DIP switches” on page5
for details on how to do this.
for details on how to do this.
• Connect the ribbon cable to the top terminal inside the printer, and
carefully slide the serial interface unit into the printer.
After sliding the interface unit in as far as it will go, secure it in place
with the two large screws that come with it.
After sliding the interface unit in as far as it will go, secure it in place
with the two large screws that come with it.