Star Micronics USB Benutzerhandbuch

                                                                        

1150 King Georges Post Rd.                                                            

Edison, NJ 08837-3729 

System Sales Team

  

Page 2 

 

Before beginning installation: 
 

•

  Must have a TSP600 (TSP613/643), TSP700 (TSP743) or TSP800 (TSP847) with 

USB2.0 ready firmware. 

 

TSP613 / TSP643 

Ver3.2 –b1.1

TSP743 Ver3.2 

–b1.1

TSP847 Ver4.3 

–b2.1

 

*** Note:  If you have a firmware version that was releases prior to the above-mentioned versions, please 

contact a Star Micronics Customer Support Specialist today to get your printer updated *** 

 

•

  Printer being used must have USB2.0 chip on printer USB interface card 

 

*** Note:  Interface version can be determined by removing interface card from the back of the printer *** 

 

•

  If the printer being used has the appropriate firmware version, change the dip 

switches as follows: 

 

Dip Switch 1- 5 / 1- 6 

1-5 Off  1-6 On 
1-6 On  1-5 Off 

Vender Class

Printer Class

OPOS

Normal Windows Operation

 

•

  If Using the printer with OPOS, the Star Micronics OPOS drivers (Version 1.4.11 or 

higher) and the Vender Class Drivers will be required 

 

*** Note:  If you do not have Version 1.4.11 of the OPOS driver or the Vender Class Driver,  

please call a Star Micronics Customer Support Specialist today *** 

 

Once all steps above are completed, installation of the USB port can occur.   
 
To begin installation of the ‘Printer Class’ USB port, go to the next page 
 
To begin installation of the ‘Vender Class’ USB port, go to page 7 
 
To begin installation of the ‘OPOS Drivers’, go to page 14 
 
To start the ‘Add Hardware Wizard’, click on ‘My Computer | Control Panel | Add/Remove 
Hardware. 
 
The ‘Add / Remove Hardware Wizard’ will open (see next page…)