Technicolor - Thomson 8900NET Benutzerhandbuch

 

The 8900NET module has two eight-position DIP switches (S1 and S2) that 
enable or disable the fault reporting functions and the variable fan speed 
option (see 

). Enabled fault alarms drive on-board LEDs and can 

also be sent to SNMP monitoring stations when the SNMP network and 
Agent software has been installed and configured (see 

 

 

Disabling (or filtering) specific fault alarms can be useful in isolating prob-
lems in the frame. Refer to 

 for the possible settings. A settings table 

is also silk-screened on the module.

 

1

PS1 Fault Reporting Enabled

PS1 Fault Reporting Disabled

2

PS2 Fault Reporting Enabled

PS2 Fault Reporting Disabled

3

(Not used) Over Temp reporting is always enabled locally and through SNMP

4

Fan Fault Reporting Enabled

Fan Fault Reporting Disabled

5

Module Fault Reporting Enabled

Module Fault Reporting Disabled

6

Frame Bus Error Reporting Enabled 

Frame Bus Error Reporting Disabled 

7

Fan Speed Controlled by Temperature

Fan Speed Fixed at Maximum

8

Network Module Control Enabled (remote 
control via GUI is enabled)

Network Module GUI is placed in read only 
mode

 

1

Status Enabled (enabled alarms are 
reported over SNMP)

SNMP Reporting is disabled except for 
Over Temp alarm

2

IP Address (not currently supported)

3

Frame Control Enabled (remote control via 
GUI is enabled)

GUI for the frame and all modules within is 
placed in read only mode

4 – 8

(Currently Not Used)

12345678

12345678

S2

S1

Power Supply #1
Power Supply #2

Temperature

Fan

Module

Frame Bus

Fan Speed

NM Control

Status

8900NET

IP Address

Frame Control

Remote

Override

LED