Technicolor - Thomson 8900NET Benutzerhandbuch

Assign a name to the input signal to the module in the 

 field.

The slot configuration for each media module is automatically saved peri-
odically (once an hour) to the 8900NET module in that frame. You may also 
select the 

 button at any time to save the current configu-

ration for this slot. The configuration is saved on the 8900NET module. If 
the 8900NET module is removed or powered down, the stored configura-
tions are not saved. 

When the 

 box has been checked, the current configuration 

saved to this slot is saved as slot memory. When the current module is 
removed and another module of the same type is installed, the configura-
tion saved to the 8900NET module will be downloaded to the new module. 
The box must be checked before the current module with the saved config-
uration is removed.

This section is a read-only status report of 8900NET module switch settings 
for Module Status Reporting and Asynchronous Status Reporting. These 
functions must be enabled for the following Slot SNMP Trap Reports to 
function.

This section is displayed only when the SNMP Agent software has been 
installed on the 8900NET module. Slot SNMP traps can be enabled only 
when the hardware switches for Module Fault reporting and Asynchro-
nous Status reporting are in enabled on the 8900NET module (dipswitch S1 
segment 7 and dipswitch S2 segment 1).

The enabled SNMP traps will be reported to any SNMP manager that is 
identified as an SNMP Report Destination in 8900NET configuration. Trap 
severity is read-only hard-coded information that is interpreted and 
responded to by the SNMP Manager software configuration.

To view or change the module identity and currently assigned network 
addresses for the 8900NET module access the Network page illustrated in 

.

Depending on the type of frame this module is installed in, this network con-
figuration is saved on either the 8900NET module or on the frame backplane. 
Refer to