Telect MIX 56 Benutzerhandbuch
MIX 56 User Manual
2 Installation
122188-10 A0
Telect, Inc.
2-5
1-800-551-4567 or 1-509-926-6000
Keep the container until you have checked equipment operation. If you ex-
perience any kind of problem, call Telect’s Customer Service Department.
Use the original, undamaged container if you are instructed to return the
MIX 56 to Telect.
perience any kind of problem, call Telect’s Customer Service Department.
Use the original, undamaged container if you are instructed to return the
MIX 56 to Telect.
I
NSTALLING
MIX 56
These procedures may be modified to agree with site practices or operating
company procedures.
company procedures.
NOTE
If you are installing the optional MIX 56 Broadband Sidecar
(PN 747-9999-2001), read the installation instructions included with the
kit before installing the MIX 56 chassis.
(PN 747-9999-2001), read the installation instructions included with the
kit before installing the MIX 56 chassis.
Attaching the Mounting Brackets
When attaching the mounting brackets, you can set the chassis to project 3,
4, or 5 inches from the front of the rack, depending on which set of holes
on the chassis you choose. The following illustration shows the standard
bracket being installed for 3-inch projection. To allow more front projec-
tion, use the middle set of holes for 4 inches or the last set of holes for 5
inches.
4, or 5 inches from the front of the rack, depending on which set of holes
on the chassis you choose. The following illustration shows the standard
bracket being installed for 3-inch projection. To allow more front projec-
tion, use the middle set of holes for 4 inches or the last set of holes for 5
inches.
NOTE
If you are mounting the chassis in a 23-inch rack, use the included extender
bracket shown in the illustration on the next page.
bracket shown in the illustration on the next page.
Step
Action
1.
Select the appropriate brackets (included) for the rack size, standard
for 19 in. racks or extender for 23 in. racks.
for 19 in. racks or extender for 23 in. racks.
2.
On one side of the chassis, insert two of the included #8-32 screws
through the bracket screw holes and into the bracket mounting
holes on the chassis, as shown in the illustration on the next page.
Choose holes that correspond to the desired front projection.
through the bracket screw holes and into the bracket mounting
holes on the chassis, as shown in the illustration on the next page.
Choose holes that correspond to the desired front projection.