Enterasys Networks 2E253 Benutzerhandbuch
HSIM/VHSIM Configuration Screen
Port Configuration Menu Screens
5-13
5.4
HSIM/VHSIM CONFIGURATION SCREEN
When to Use
To configure an optional HSIM or VHSIM.
How to Access
Use the arrow keys to highlight the HSIM/VHSIM CONFIGURATION menu item on the Port
Configuration Menu screen and press ENTER. The applicable HSIM or VHSIM setup screen
displays. Refer to the appropriate HSIM or VHSIM user’s guide for instructions on using the Local
Management screens for that interface.
Configuration Menu screen and press ENTER. The applicable HSIM or VHSIM setup screen
displays. Refer to the appropriate HSIM or VHSIM user’s guide for instructions on using the Local
Management screens for that interface.
5.5
REDIRECT CONFIGURATION MENU SCREEN
Screen Navigation Path
Password > Device Menu > Device Configuration Menu > Port Configuration Menu > Redirect
Configuration Menu
Configuration Menu
When to Use
To access the Port Redirect Configuration and VLAN Redirect Configuration screens. Any
combination, up to 128, of port and/or VLAN redirect instances can be configured from these
screens. This feature is useful in troubleshooting. It enables you to monitor traffic at a destination
port using analyzers, RMON probes, and IDS sensors.
combination, up to 128, of port and/or VLAN redirect instances can be configured from these
screens. This feature is useful in troubleshooting. It enables you to monitor traffic at a destination
port using analyzers, RMON probes, and IDS sensors.
How to Access
Use the arrow keys to highlight the REDIRECT CONFIGURATION MENU item on the Port
Configuration Menu screen and press ENTER. The Redirect Configuration Menu screen,
Configuration Menu screen and press ENTER. The Redirect Configuration Menu screen,
, displays.
NOTE: The HSIM/VHSIM Configuration menu item can only be selected when a
non-Ethernet HSIM or VHSIM is installed in the switch device. The applicable setup
screen for that interface displays. This only applies to HSIMs and VHSIMs that can
support WAN, FDDI or ATM. Refer to the appropriate HSIM or VHSIM user’s guide to set
its operating parameters.
non-Ethernet HSIM or VHSIM is installed in the switch device. The applicable setup
screen for that interface displays. This only applies to HSIMs and VHSIMs that can
support WAN, FDDI or ATM. Refer to the appropriate HSIM or VHSIM user’s guide to set
its operating parameters.