RGB Spectrum Quadra User's Guide Benutzerhandbuch
I N S T A L L A T I O N A N D S E T U P
System Timing
350-7951
Quadra User’s Guide
19
.
. .
.
.
With the IP address and port properly entered, the Telnet window
opens and Quadra responds with the product name and copyright
notice as shown in the sample below.
opens and Quadra responds with the product name and copyright
notice as shown in the sample below.
Figure 2-5.
Quadra
Login (Sample)
4.
To confirm the connection, in the Telnet window type:
ID
…
and press
Enter
. Quadra responds with a variety of product details
including the unit’s IP settings.
You can now control Quadra directly by issuing ASCII commands
from the Telnet terminal. Refer to Chapter 4, “
from the Telnet terminal. Refer to Chapter 4, “
” for a complete command list.
5.
Please continue with the “
” section.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
S Y S T E M T IM IN G
The following topics are outlined in this section:
•
Introduction to Timing
•
•
•
INTRODUCTION TO
. . . . . . . . .
TIMING
For the best visual results with Quadra, the timing parameters of a signal must
match the display device. Please note:
match the display device. Please note:
•
For each of Quadra’s four output channels, each channel’s output
settings should match the connected display.
settings should match the connected display.
•
For each of Quadra’s four graphics inputs, Quadra’s input settings
should match the characteristics of the input signals.
should match the characteristics of the input signals.
Note
To close a Telnet session, type
EXIT
or use the keystroke
sequence “
Control + D
.”