Martin Fireplaces 2518 Benutzerhandbuch
17
T
O
CLEAR
AUTO
-
START
This procedure clears the memory lock and auto-start functions: to reset the memory
lock see page 22.
lock see page 22.
1.
Turn off the controller. In tandem mode, turn off the top controller.
2.
Turn on the controller and immediately press and hold the top 3
channel buttons until “ON” or “OF” is displayed.
channel buttons until “ON” or “OF” is displayed.
3.
Repeat.
B
LACKOUT
/
STANDBY
In blackout mode, the controller blacks out lights by sending DMX value 0 on all
channels.
channels.
In standby mode, there is no DMX output from the controller. Fixtures will behave
differently when the DMX signal stops: some will blackout, some will keep their last
look, and some will run in stand-alone mode. Standby mode uses very little current
and is recommended whenever the controller is not being used for extended periods.
differently when the DMX signal stops: some will blackout, some will keep their last
look, and some will run in stand-alone mode. Standby mode uses very little current
and is recommended whenever the controller is not being used for extended periods.
T
O
BLACKOUT
ALL
FIXTURES
1.
Press [Blackout]. The display flashes.
2.
Press [Blackout] again to resume operation.
T
O
TOGGLE
STANDBY
MODE
1.
Press and hold [Blackout] until the display clears.
2.
To return to normal execution, press [Blackout] again.
Power-on
commands may be executed immediately after pressing the button.