Moxa Technologies 5400 Series Benutzerhandbuch

 

1.  Determine whether your NPort needs to use a Static IP or Dynamic IP (either DHCP or 

BOOTP application). 

2.  If the NPort is used in a Static IP environment, you can use LCM Display, NPort 

Administration Suite, ARP, Web Console, or Telnet Console to configure the new IP address. 

3.  If the NPort is used in a Dynamic IP environment, you can use LCM Display, NPort 

Administration suite, Web Console, or Telnet Console to configure the NPort to get an IP 
address dynamically with DHCP, DHCP/BOOTP, or BOOTP. 

 

ATTENTION 

Consult your network administrator on how to reserve a fixed IP address for your NPort 5400 in 
the MAC-IP mapping table when using a DHCP Server or BOOTP Server. In most applications, 
you should assign a fixed IP address to your NPort.

 

 

NPort products are configured with the following default private IP address: 

192.168.127.254 

(IP addresses of the form 192.168.xxx.xxx are referred to as private IP addresses, since it is not 
possible to directly access a device configured with a private IP address from a public network. 
For example, you would not be able to ping such a device from an outside Internet connection. 
NPort applications that require sending data over a public network, such as the Internet, require 
setting up the server with a valid public IP address, which can be leased from a local ISP.) 

We recommend using LCM display and four push buttons to configure the IP address at the first 
time installation. 

 

If the NPort is working properly, the LCM panel will display a green color. The red Ready LED 
will also light up, indicating that the NPort is receiving power. After the red Ready LED turns to 
green, you will see a display similar to: 

   

N P 5 4 1 0 _ 6 1 4 0 5        
1 9 2 .  1 6 8 .  1 2 7 .  2 5 4  

 

This is where 

•  NP5410 

 

 

 

is the NPort’s name 

•  61405 

 

 

 

is the NPort’s serial number 

•  192.168.127.254 

 

is the NPort’s IP address