ZyXEL Communications P-870HW-51a v2 Benutzerhandbuch

 Chapter 10 Static Route

P-870HW-51a v2 User’s Guide

Click the Add button in the Static Route screen. Use this screen to configure the 
required information for a static route. 

Figure 62   Static Route: Add 

The following table describes the labels in this screen. 

Table 36   Static Route: Add

Destination IP 
Address

This parameter specifies the IP network address of the final destination.  
Routing is always based on network number. If you need to specify a 
route to a single host, use a subnet mask of 255.255.255.255 in the 
subnet mask field to force the network number to be identical to the host 
ID.

IP Subnet 
Mask 

Enter the IP subnet mask here.

Use Interface

Select a WAN interface through which the traffic is sent. You must have 
the WAN interface(s) already configured in the WAN screens. If you 
select a WAN interface using ENET ENCAP you must specify the gateway 
IP address.

Use Gateway 
IP Address

Select this option and enter the IP address of the next-hop gateway. The 
gateway is a router or switch on the same segment as your ZyXEL 
Device's interface(s). The gateway helps forward packets to their 
destinations.

Back

Click Back to return to the previous screen without saving.

Apply

Click Apply to save your changes back to the ZyXEL Device.

Cancel

Click Cancel to begin configuring this screen afresh.