McDATA 3000 Benutzerhandbuch
8
8-14
McDATA UltraNet Edge 3000 User Guide
Configuring a 1x1 Ethernet Wide Area Network
NOTE:
Use I/O port 3 for all 1x1 configurations. When configuring a 2x2, use
I/O port 3 to connect the first circuit and I/O port 4 for the second circuit.
The IP Circuit Wizard Node10 Configure Interface dialog box
appears.
appears.
This dialog box enables you to configure the IP WAN interface
properties for Node10.
properties for Node10.
7. Enter the IP Address (IP WAN address) and the Subnet Mask.
The IP WAN address must be different from the Ethernet
maintenance interface address.
maintenance interface address.
NOTE:
If you are using the Configuration IP Address Worksheet, enter the
following information:
For Node10, enter the IP address labeled
For Node10, enter the IP address labeled
for the circuit on a 1x1 or 2x1
configuration or the 1st circuit of a 1x2 or 2x2.
For the 2nd circuit of a 1x2 or 2x2 configuration, enter the IP address labeled
For the 2nd circuit of a 1x2 or 2x2 configuration, enter the IP address labeled
.
8. Click Next>.
The IP Circuit Wizard Node10 Configure Gateway dialog box
appears.
appears.
The gateway IP address entered in this dialog box will be the
router IP WAN address attached to the UltraNet Edge 3000
(Node10).
router IP WAN address attached to the UltraNet Edge 3000
(Node10).