Paradyne 9820-8M Benutzerhandbuch
Configuration Options
4-56
9820-A2-GB20-20
June 2000
Table 4-17.
Communication Port Options (5 of 5)
RIP
Possible Settings: None, Proprietary, Standard_out
Default Setting: None
Default Setting: None
Specifies which Routing Information Protocol (RIP) is used to enable routing of
management data between devices.
management data between devices.
Display Conditions – This option only appears when Port Use is set to Net Link.
None – No routing is used.
Proprietary – (Models 9820, 9820-2M, 9820-8M.) A proprietary variant of RIP version 1
is used to communicate routing information only between devices to enable routing of
IP traffic.
is used to communicate routing information only between devices to enable routing of
IP traffic.
Standard_out – The device will send standard RIP messages to communicate routing
information about other FrameSaver units in the network. Standard RIP messages
received on this link are ignored.
information about other FrameSaver units in the network. Standard RIP messages
received on this link are ignored.
NOTE:
The router must be configured to receive RIP on the port connected to the
COM (Terminal) port, configured as the management interface (e.g., Cisco:
COM (Terminal) port, configured as the management interface (e.g., Cisco:
config-t, router RIP, int serial
x, IP RIP Receive
version 1, ctl-z WR
).