Zoom 4401A Benutzerhandbuch

Z O O M   A P + 4  

This Quick Start tells you how to install the AP+4 and configure 
wireless security. For additional information about other topics, 
please see the User Guide

Connecting the Hardware 
1 

Put the AP+4 near a computer to be used for setup. That 
computer needs an Ethernet (LAN) port. 

2 

Turn off the computer. 

3 

Plug the supplied power cube into the AP+4, and then into a 
power outlet.  

Important! Use only the power cube shipped with the AP+4. 
Other power cubes may damage the device. 

The PWR LED on the AP+4 front panel should turn on and 
within a few seconds the WLAN LED should flash. (The 
WLAN LED continues to flash to signify broadcast activity as 
long as the Wireless LAN is enabled. It is enabled by 
default.) 

4 

Connect one end of the supplied Ethernet cable to the 
computer’s Ethernet port and the other end to any of the 
AP+4’s LAN ports. 

5 

Turn on the computer. The connected LAN port and the 
ACT (Activity) LEDs immediately become steady on. (If you 
have a 10 Mbps Ethernet connection, the LAN LED does not 
turn on.) 

6 

If you want the AP+4 to have access to the Internet, connect 
its WAN port to the Ethernet port on your cable modem, 
ADSL modem, or other broadband device. When you do 
this, the WAN LED turns on if the broadband device is on 
and its Ethernet port is working.