SonicWALL EM5000 Benutzerhandbuch

Page 88

  Replacing a Single Hard Drive  

Inserting the Replacement Drive into the SonicWALL 
UMA EM5000

To view the hard drive array and insert the replacement drive 
into the SonicWALL UMA EM5000, perform the following steps:

1.

Remove the hard drive and the drive number stickers from 
the replacement drive shipping carton.

2.

Depending on which drive you are replacing, apply the 
appropriate sticker to the drive handle. While holding the 
drive with the label side up, place the sticker near the edge 
of the handle next to the square button.

3.

In the appliance Web interface, navigate to the System > 
RAID page.

4.

Pop open the drive handle on the new hard drive by 
pressing the square button. 

5.

Insert the drive into the empty slot, label side up with the 
handle sticking out.

6.

Press the drive firmly into place to seat the connectors, and 
then close the handle.

7.

Click Refresh on the System > RAID page. You will see 
the drive slot status change to DEGRADED, and the Array 
Status change to REBUILD-PAUSED.

The DEGRADED drive status indicates that the RAID 
controller senses that data is missing from the drive. The 
Array Status will change to REBUILDING within a few 
minutes.

8.

You may continue to use your SonicWALL UMA EM5000 
while the RAID controller rebuilds the array with the new 
drive. The rebuilding process requires at least three hours.
When finished rebuilding, the status for both the drive and 
the array changes to OK on the System > RAID page.

9.

Re-install the front bezel, being sure to properly line up the 
LCD connectors. The best practice is to align and seat the 
right side of the bezel (as you are facing the front of the 
SonicWALL UMA EM5000), then view the connectors from 
above as you carefully press the left side of the bezel into 
place.

10. Lock the bezel with the front bezel security key.