Siemens Santis ADSL 50 Benutzerhandbuch
Verify that the following items came with your SANTIS ADSL 50 kit:
Optional:
Your service provider may include analog Y-Line Filters or Belgium Line Filters. If you have
received any of these items, follow the instructions provided in this guide for “Hardware
installation”. If you need further assistance installing these items, please contact your servi-
ce provider.
Your service provider may include analog Y-Line Filters or Belgium Line Filters. If you have
received any of these items, follow the instructions provided in this guide for “Hardware
installation”. If you need further assistance installing these items, please contact your servi-
ce provider.
Before starting the installation of the SANTIS ADSL 50, make sure your computer is
equipped with:
one of the following operating system (OS):
Windows 98 SE, ME, NT, 2000 or XP if your computer is equiped with a LAN interface
(Ethernet or WiFi)
Note:
equipped with:
one of the following operating system (OS):
Windows 98 SE, ME, NT, 2000 or XP if your computer is equiped with a LAN interface
(Ethernet or WiFi)
Note:
Windows N
NT uusers pplease rrefer tthe ffull m
manual tto cconfigure tthe TTCP/IP ssettings.
Before yyou bbegin:
Quick Start Guide
CD-ROM
ADSL cord
(silver)
(silver)
Power supply
Ethernet cable
(light gray)
(light gray)
SANTIS ADSL 50
Belgium Line Filter
2
Power cord
Ethernet (LAN) interface
Y-Line Filter
11
Step 55:
Front ppanel ssystem m
Front ppanel ssystem m
messages
The following illustration shows the front panel of the ADSL Router-modem:
LED IIndicators
The ADSL Router-modem is equipped with LEDs on the front panel as described in the table
below (from left to right):
below (from left to right):
LED
Color
Status
Description
PWR
Green Off
Power
off
On
Power on
DIAG
Green
Off
Power off or initial self-test of the unit is OK
Blinking
When software downloading or updating operation
parameters located in FLASH memory is in progress
parameters located in FLASH memory is in progress
On
Initial self-test failure or programming FLASH memory
failure
failure
LAN1
Green
Off
Power off or no Ethernet carrier is present.
to
Blinking
Ethernet carrier is present and user data is going
LAN4
through Ethernet port
On
Ethernet carrier is present
WLAN
Green
Off
Power off or no radio signal (WLAN card is not present
or fails to function)
or fails to function)
Blinking
Traffic is going through Wireless LAN interface
On
Wireless LAN interface is ready to work
DSL
Green
Off
Power off or ADSL line connection is handshaking or
training is in progress
training is in progress
Blinking
User data is going through ADSL port
On
ADSL line connection is OK