Enterasys Networks 1H582-xx Benutzerhandbuch
Spanning Tree Configuration Command Set
Reviewing and Setting Spanning Tree Bridge Parameters
6-26
Example
This example shows how to reset the bridge maximum aging time:
6.2.1.25 set spantree fwddelay
Use this command to set the Spanning Tree forward delay. This is the maximum time (in seconds)
the root device will wait before changing states (i.e., listening to learning to forwarding). This
delay is required because every device must receive information about topology changes before it
starts to forward frames. In addition, each port needs time to listen for conflicting information that
would make it return to a blocking state; otherwise, temporary data loops might result.
the root device will wait before changing states (i.e., listening to learning to forwarding). This
delay is required because every device must receive information about topology changes before it
starts to forward frames. In addition, each port needs time to listen for conflicting information that
would make it return to a blocking state; otherwise, temporary data loops might result.
set spantree fwddelay delay
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the bridge forward delay to 16 seconds:
6.2.1.26 clear spantree fwddelay
Use this command to reset the bridge forward delay to the default setting of 15 seconds.
clear spantree fwddelay
Syntax Description
None.
Matrix>clear spantree maxage
delay
Specifies the number of seconds for the bridge forward
delay. Valid values are 4 - 30.
delay. Valid values are 4 - 30.
Matrix>set spantree fwddelay 16