Enterasys Networks 9033900-04 Benutzerhandbuch
Command Groups
A-46
ip pppoe
This command enables PPPoE on the Ethernet interface. Use the no form to disable PPPoE on the
Ethernet interface.
Ethernet interface.
Syntax
ip pppoe
no ip pppoe
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet)
Command Usage
The access point uses a PPPoE connection, or tunnel, only for management traffic between the
access point and a remote PPPoE server (typically at an ISP). Examples of management traffic
that may initiated by the access point and carried over a PPPoE tunnel are RADIUS, Syslog, or
DHCP traffic.
access point and a remote PPPoE server (typically at an ISP). Examples of management traffic
that may initiated by the access point and carried over a PPPoE tunnel are RADIUS, Syslog, or
DHCP traffic.
Example
RoamAbout 3000#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 3000(config)#interface ethernet
Enter Ethernet configuration commands, one per line.
RoamAbout 3000(if-ethernet)#ip pppoe
RoamAbout 3000(if-ethernet)#