Foundry Networks AR1216 Benutzerhandbuch

OSPF Configure Commands

June 2004

© 2004 Foundry Networks, Inc.

9 - 29

This command configures the OSPF network type on an interface.

[ no ] network < broadcast | non_broadcast | point_to_multipoint | point_to_point >

NOTE: If the interface type is point-to-point, then to change the network type to broadcast, the user must first 
change the point-to-point interface to broadcast type using the ip address command.

NOTE: The “non_broadcast” and “point_to_multipoint” parameters are not supported in this release.

Foundry-AR1208/configure/router/ospf/interface toBoston# network non_broadcast

interface type

network type default 

PPP/HDLC

point-to-point

Ethernet

broadcast

Frame Relay

point-to-point

network type

broadcast

Configures network type to broadcast multi-access network

non_broadcast

Configures network type to nonbroadcast multiaccess (NBMA) 
network

point_to_multipoint

Configures network type to point-to-multipoint network

point_to_point

Configures network type to point-to-point network

configure router ospf interface authentication

configure router ospf interface cost

configure router ospf interface dead_interval

configure router ospf interface hello_interval

configure router ospf interface neighbor

configure router ospf interface poll_interval

configure router ospf interface priority

configure router ospf interface retransmit_interval

configure router ospf interface transmit_delay