QSC Audio RAVE 160 Benutzerhandbuch

This diagram shows the pinout for standard unshielded twisted-pair (UTP) network cable. Both ends of the cable

are wired identically.

A crossover cable has the RX and TX wire pairs switched around at one end. There are only two likely situations

that would require a crossover cable: to connect two RAVE devices directly, without a hub or other device in

between; and to cascade hubs that don’t have uplink ports.

The wire in UTP cabling is twisted together in pairs. Rather than randomly choosing a wiring scheme for the

networking cable, it is important to have the RX wires in one pair and the TX wires in another pair, especially

in longer cable runs.

Pin assignments of 9-pid female D connector:

Pin 2: TX out

Pin 3: RX in

Pin 5: Ground

Pins 1 (DCD), 4 (DSR), and 6 (DTR) are tied together. Pins 7 (RTS) and 8 (CTS) are also tied together. DCE (receives

on TD) operation; parity bit not checked.