Trango Broadband Atlas5010 Benutzerhandbuch
Appendix A
Command Set Reference
Trango Broadband Wireless — Atlas5010
page 42
Link Control
The Link Control page features the RF Link Loopback / Speed Test. In this test, the user specifies the transmission rate
(in Mbps) in both the local radio and the peer radio as well as the duration time (in minutes) for the test. During the test,
the local radio will transmit packets across the wireless link. The peer radio will retransmit equivalent packets back to
the local radio. The test will measure and report error rate and actual throughput as measured in Mbps. The following
link test was run for 60 seconds with a specified TX rate of 12 Mbps per end.
To run a link loopback test, both radios must be in Opmode ON and status “Connected”
The Link Control page features the RF Link Loopback / Speed Test. In this test, the user specifies the transmission rate
(in Mbps) in both the local radio and the peer radio as well as the duration time (in minutes) for the test. During the test,
the local radio will transmit packets across the wireless link. The peer radio will retransmit equivalent packets back to
the local radio. The test will measure and report error rate and actual throughput as measured in Mbps. The following
link test was run for 60 seconds with a specified TX rate of 12 Mbps per end.
To run a link loopback test, both radios must be in Opmode ON and status “Connected”
In this example, the error rate was 2 packets from MU to RU and 0 packets from RU to MU. Measured aggregate
bandwidth is 10.93 Mbps.