ZyXEL Communications P-660RU-Tx Benutzerhandbuch

 Chapter 1 Introducing the P-660RU-Tx

P-660RU-Tx User’s Guide

Refer to the Quick Start Guide for information on hardware connections. 

If you forget your password or cannot access the web configurator, you will need 
to use the RESET button at the back of the device to reload the factory-default 
configuration file. This means that you will lose all configurations that you had 
previously and the password will be reset to “1234”.

Make sure the POWER LED is on (not blinking).

To set the device back to the factory default settings, press the RESET button for 
ten seconds or until the POWER LED begins to blink and then release it. When the 
POWER LED begins to blink, the defaults have been restored and the device 
restarts.

The USB port is useful if you have an USB-enabled computer that does not have a 
network interface card for attaching to your Ethernet network. See the following 
sections for USB driver installation procedures in your operating system.

• Windows 98 (Second Edition), Windows Me (Millennium Edition), Windows 

2000, Windows XP or Windows Vista

• An  available  USB  port

Note: Install the USB driver before you connect the P-660RU-Tx to the USB port.

USB

Green

On

There is a USB connection.

Blinking

The P-660RU-Tx is sending or receiving data via the 
USB port.

Off

There is no USB connection.

Table 1   LED Descriptions