ZyXEL Communications NWA1100-N Benutzerhandbuch

Chapter 11 IP Screen

NWA1100-N User’s Guide

Use this screen to configure the IP address for your NWA. Click IP to display the following screen.

IP Setup

The following table describes the labels in this screen.

IP Setup

Obtain IP Address 
Automatically 

Select this option if your NWA is using a dynamically assigned IP address 
from a DHCP server each time. 

Note: You must know the IP address assigned to the NWA (by the DHCP 

server) to access the NWA again. 

Use Fixed IP Address

Select this option if your NWA is using a static IP address. When you select 
this option, fill in the fields below.

IP Address

Enter the IP address of your NWA in dotted decimal notation. 

Note: If you change the NWA's IP address, you must use the new IP address 

if you want to access the web configurator again.

Subnet Mask

Type the subnet mask.

Gateway IP Address 

Type the IP address of the gateway. The gateway is an immediate neighbor 
of your NWA that will forward the packet to the destination. On the LAN, 
the gateway must be a router on the same segment as your NWA; over the 
WAN, the gateway must be the IP address of one of the remote nodes.

Spanning Tree

(R)STP (

) detects and breaks network loops and 

provides backup links between switches, bridges or routers. It allows a 
bridge to interact with other (R)STP -compliant bridges in your network to 
ensure that only one path exists between any two stations on the network. 
Select the check box to activate STP on the NWA.

Apply

Click Apply to save your changes.

Reset

Click Reset to begin configuring this screen afresh.