ZyXEL Communications G-2000 Plus Benutzerhandbuch

ZyAIR G-2000 Plus User’s Guide

Chapter 25 Remote Node Configuration

282

The ZyAIR supports PPPoE (Point-to-Point Protocol over Ethernet). You can only use PPPoE 
encapsulation when you’re using the ZyAIR with a DSL modem as the WAN device. If you 
change the Encapsulation to PPPoE, then you will see the next screen. Please see the 
appendix for more information on PPPoE.

Route

This field refers to the protocol that will be routed by your ZyAIR – IP is the only 

option for the ZyAIR.

ISP

Use  [SPACE BAR] to select Yes to use your ISP.

Apply Alias

The ZyAIR supports three logical LAN interfaces via its single physical Ethernet 

interface with the ZyAIR itself as the gateway for each LAN network. Press 

[SPACE BAR] to select IP Alias 1or 2 and then press [ENTER].

Edit IP

This field leads to a “hidden” menu. Press [SPACE BAR] to select Yes and press 

[ENTER] to go to Menu 11.3 - Remote Node Network Layer Options.

Session Options

 Edit Filter Sets

This field leads to another “hidden” menu. Use  [SPACE BAR] to select Yes and 

press [ENTER] to open menu 11.5 to edit the filter sets. See the Remote Node 

Filter section for more details.

Once you have configured this menu, press [ENTER] at the message “Press ENTER to Confirm...” to 

save your configuration, or press [ESC] at any time to cancel.

Table 95   Menu 11.1 Remote Node Profile for Ethernet Encapsulation