ZyXEL Communications G-2000 Plus Benutzerhandbuch

ZyAIR G-2000 Plus User’s Guide

Chapter 31 SNMP Configuration

330

Menu 22 - SNMP Configuration

SNMP:
  Get Community= public
  Set Community= public
  Trusted Host= 0.0.0.0
  Trap:
    Community= public
    Destination= 0.0.0.0

Press ENTER to Confirm or ESC to Cancel:

The following table describes the SNMP configuration parameters.

Table 110   Menu 22 SNMP Configuration

SNMP:

Get Community

Type the Get Community, which is the password for the incoming Get- and 

GetNext requests from the management station.

Set Community

Type the Set Community, which is the password for incoming Set requests from 

the management station. 

Trusted Host

If you enter a trusted host, your ZyAIR will only respond to SNMP messages from 

this address. A blank (default) field means your ZyAIR will respond to all SNMP 

messages it receives, regardless of source.

Trap:

Community

Type the trap community, which is the password sent with each trap to the SNMP 

manager. 

Destination

Type the IP address of the station to send your SNMP traps to.

When you have completed this menu, press [ENTER] at the prompt “Press ENTER to confirm or ESC 

to cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.

The ZyAIR will send traps to the SNMP manager when any one of the following events 
occurs:

Table 111   SNMP Traps

1

coldStart (defined in RFC-1215)

A trap is sent after booting (power on).

2

warmStart (defined in RFC-1215)

A trap is sent after booting (software reboot).

3

linkUp (defined in RFC-1215)

A trap is sent when the port is up.