ZyXEL Communications G-2000 Plus Benutzerhandbuch

ZyAIR G-2000 Plus User’s Guide

Chapter 2 Introducing the Web Configurator

46

If you forget your password or cannot access the web configurator, you will need to reload the 
factory-default configuration file or use the RESET button on the side panel of the ZyAIR. 
Uploading this configuration file replaces the current configuration file with the factory-
default configuration file. This means that you will lose all configurations that you had 
previously and the speed of the console port will be reset to the default of 9600bps with 8 data 
bit, no parity, one stop bit and flow control set to none. The password will be reset to 1234, 
also.

.

Make sure the SYS LED is on (not blinking) before you begin this procedure. 

Press

 the RESET button for ten seconds or until the SYS LED, LINK LED or BRI/RPT 

LED turns red, and then release it. If the SYS LED begins to blink, the defaults have been 
restored and the ZyAIR restarts. Otherwise, go to step 2.

Turn the

 ZyAIR off.

While

 pressing the RESET button, turn the ZyAIR on.

Continue 

to hold the RESET button. The SYS LED will begin to blink and

 

flicker very 

quickly after about 20 seconds. This indicates that the defaults have been restored and the 
ZyAIR is now restarting.

Release

 the RESET

button and wait for the ZyAIR to finish restarting.

Use the web configurator to restore defaults (refer to the Maintenance chapter).

The following summarizes how to navigate the web configurator from the MAIN MENU 
screen.

Note: Follow the instructions you see in the MAIN MENU 
screen or click the 

 icon (located in the top right corner of 

most screens) to view online help.

The 

 icon does not appear in the MAIN MENU screen.