ZyXEL Communications omni series Benutzerhandbuch
Installing omni External Models 9
Front Panel Switch
When the TA is in command state, pressing the front panel button
causes it to dial the default phone number pre-stored in the NVRAM.
The default number pointer to the telephone directory is assigned by
the AT*Dn command.
causes it to dial the default phone number pre-stored in the NVRAM.
The default number pointer to the telephone directory is assigned by
the AT*Dn command.
When the TA is on-line, pressing the button will tear down the
connection and bring it into command state.
connection and bring it into command state.
To restore the TA to its factory default settings and initiate the
loop-back test, turn the power ON while pressing and holding the
switch. Continue holding the switch for 3 to 5 seconds after turning
the power ON.
loop-back test, turn the power ON while pressing and holding the
switch. Continue holding the switch for 3 to 5 seconds after turning
the power ON.
Back Panel
You will find the following switch and connectors on the back panel
of the omni external models:
of the omni external models:
Figure 2-1 omni.net Back Panel
ON/OFF - Power switch; turns the omni ON or OFF.
POWER - Input terminal for power adapter.
To DTE - Serial port DB-25 female connector for connection to the
serial port of a DTE (computer/terminal).
serial port of a DTE (computer/terminal).
ISDN - ISDN RJ-45 terminal jack; connects to a S/T interface or a U
interface.
interface.
PHONE 1 (omni.net) - RJ-11 terminal jack for analog adapter 1; for
connecting to analog equipment. (phone, fax, answering machine,
etc.)
connecting to analog equipment. (phone, fax, answering machine,
etc.)