ZyXEL Communications 200 Series Benutzerhandbuch
Chapter 10 Interface
ZyWALL USG 100/200 Series User’s Guide
206
Each section in this screen is described below.
10.4 The Ethernet Summary Screen
This screen lists every Ethernet interface and virtual interface created on top of Ethernet
interfaces. To access this screen, click Network > Interface > Ethernet.
interfaces. To access this screen, click Network > Interface > Ethernet.
Unlike other types of interfaces, you cannot create new Ethernet interfaces nor can you delete
any of them. If you do not assign any physical ports to one of the lan1, ext-wlan, or dmz
Ethernet interfaces (see
any of them. If you do not assign any physical ports to one of the lan1, ext-wlan, or dmz
Ethernet interfaces (see
), the Ethernet interface is effectively
removed from the ZyWALL, but you can still configure it.
Ethernet interfaces are similar to other types of interfaces in many ways. They have an IP
address, subnet mask, and gateway used to make routing decisions. They restrict the amount of
bandwidth and packet size. They can provide DHCP services, and they can verify the gateway
is available.
address, subnet mask, and gateway used to make routing decisions. They restrict the amount of
bandwidth and packet size. They can provide DHCP services, and they can verify the gateway
is available.
Use Ethernet interfaces to control which physical ports exchange routing information with
other routers and how much information is exchanged through each one. The more routing
information is exchanged, the more efficient the routers should be. However, the routers also
generate more network traffic, and some routing protocols require a significant amount of
configuration and management. The ZyWALL supports two routing protocols, RIP and OSPF.
See
other routers and how much information is exchanged through each one. The more routing
information is exchanged, the more efficient the routers should be. However, the routers also
generate more network traffic, and some routing protocols require a significant amount of
configuration and management. The ZyWALL supports two routing protocols, RIP and OSPF.
See
for background information about these routing protocols.
Table 49 Network > Interface > Port Role
LABEL
DESCRIPTION
LAN1/WLAN/DMZ
PX~P7
PX~P7
These are physical Ethernet ports.
lan1 (LAN1)
ext-wlan (WLAN)
dmz (DMZ)
ext-wlan (WLAN)
dmz (DMZ)
These are Ethernet interfaces and the zone to which each belongs. Use the
radio buttons to select for which interface (network) you want to use each
physical port. For example, select a port’s LAN1 radio button to use the port as
part of the lan1 interface. The port will use the ZyWALL’s lan1 IP address and
MAC address.
When you assign more than one physical port to a network, you create a port
group. Port groups have the following characteristics:
•
radio buttons to select for which interface (network) you want to use each
physical port. For example, select a port’s LAN1 radio button to use the port as
part of the lan1 interface. The port will use the ZyWALL’s lan1 IP address and
MAC address.
When you assign more than one physical port to a network, you create a port
group. Port groups have the following characteristics:
•
There is a layer-2 Ethernet switch between physical ports in the port group.
This provides wire-speed throughput but no security.
This provides wire-speed throughput but no security.
•
It can increase the bandwidth between the port group and other interfaces.
•
The port group uses a single MAC address.
Apply
Click this button to save your changes and apply them to the ZyWALL.
Reset
Click this button to change the port groups to their current configuration (last-
saved values).
saved values).